Sunlite ST40Y48M10X6- Manual do Utilizador Página 1

Consulte online ou descarregue Manual do Utilizador para Dispositivos óticos Sunlite ST40Y48M10X6-. Sunlite ST40Y48M10X6- Manuel d'utilisation Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 2
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
Model Max Input Voltage (Vdc) Max current (a) Max Wattage
ST40 48 3.5 66
Important Safety InStructIonS - Save theSe InStructIonS
uSe only wIth claSS 2 power unIt
• These products are only suitable for connection to a Class 2 power source
and have not been evaluated for use when connected to a power source
that does not comply with Class 2 voltage and energy limited supplies.
cautIon - to prevent the rISk of fIre, do not InStall In
a compartment Smaller than 10 IncheS by 10 IncheS by
(xx+12) IncheS (where xx IS the length of the lumInaIre In
IncheS)
all InStallatIonS of SunStrIp40 Should be
performed by a certIfIed electrIcIan and be In
complIance wIth the natIonal electrIcIanS code aS well
aS local codeS.
SuItable for wet locatIonS
conSIgneS de SÉcurItÉ ImportanteS - conServeZ SoIgneuSement ceS InStructIonS
a utIlISer unIQuement avec une Source d’alImentatIon de
claSSe 2
• Ces produits doivent être branchés uniquement à une source d’alimen-
tation de classe 2 et n’ont pas été testés pour une utilisation lors d’une
connexion à une source d’énergie non conforme à la tension de classe 2
et à l’approvisionnement en énergie limitées.
attentIon - pour ÉvIter leS rISQueS d’IncendIe, ne paS
InStaller danS un compartIment InferIeur a 10 pouceS
Sur 10 pouceS Sur (xx+12) pouceS (oÙ xx eSt la longueur
du lumInaIre en pouceS).
ce produIt doIt Étre InStallÉ Selon le code
d’InStallatIon pertInent, par une perSonne QuI connaÍt
bIen le produIt et Son fonctIonnement aInSI Que leS
rISQueS InhÉrentS.
convIent aux emplacementS mouIllÉS.
E338721
Fixture Wiring:
Solid State led
St40
Strip light
Swivel mount
C
ertiFiCation:
UL and cUL
Damp/Wet Location Listed
IP64/IP66 Rated
energy:
>0.9 Power Factor
700-1400mA / ~ 48VDC
-30° C to 40°C
ContaCt:
4811 Quail Crest Place
Lawrence, KS 66049
www.sunlitest.com
T:785.856.0219
Fixture inStallation inStruCtionS:
SunStrip40 - “St40-” - low voltage claSS 2 led luminaire
Suggested wiring utilizes bullet connections in alignment with the direction of current ow from the driver.
turn power off before any inStallation, inSpection or removal of fixture/wiring.
Strip Driver
W (-)
W (+)
B (-)
R (+)
Side with clip is positive.
inStructionS below are for one of the two mountS on the fixture. repeat theSe StepS for the other mount.
Cut 1-1/8” hole in ceiling.
Drill 1-1/16” hole in ceiling. Hole location should be
near where the xture wires will be once mounted on
ceiling. Drill two holes for the #8 screws.
Retrieve wires in ceiling and outt with bullet
connections.
Side of wire closer to LED driver should be tted with
a female bullet connector.
Side of the wire farther from the LED driver should be
tted with a male bullet connector.
Outt xture wire with bullet connections.
Core (+) with a male bullet connector.
Shield (-) with a female bullet connector.
1 2 3
Connect xture wires and ceiling wires together (See
Fixture Wiring Diagram). Place xture in desired
location and insert two #8 screws to secure the xture.
#8 ScrewS are Supplied by otherS.
Vista de página 0
1 2

Resumo do Conteúdo

Página 1 - Fixture Wiring:

Model Max Input Voltage (Vdc) Max current (a) Max WattageST40 48 3.5 66Important Safety InStructIonS - Save theSe InStructIonSuSe only wIth claSS 2 po

Página 2 - DriVer recommenDationS:

www.SunliteSt.com 4811 Quail creSt Place t: 785.856.0219connect lawrence, KS 66049 08/19/14Solid State ledST40Strip lightSwivel mountDimming Wiring:0

Comentários a estes Manuais

Sem comentários